1、

Calculation Method of Allowable External Pipe Load Applied to Brazed Aluminum Heat Exchanger Header and Its Application

板翅式换热器封头许用接管外载荷计算方法及应用

互联网摘选

2、

Research on the method for calculating allowable external pipe load applied to brazed aluminum heat exchanger based on limit analyse

基于极限分析的铝板翅式换热器封头许用接管载荷计算方法研究

互联网摘选

3、

The allowable stress number, load, geometry parameters and life have the most significant effects on pitting resistance rating results;

试验齿轮的应力修正系数、载荷和几何参数对弯曲强度计算结果的影响较大。

互联网摘选

4、

For the traditional Doherty power amplifier, the current of the peaking amplifier could not get to the maximum allowable level that the load modulation of both amplifiers was unable to achieve the optimized impedance at the maximum output and resulted in the efficiency degeneration because its low bias.

对于传统Doherty放大器,由于峰值放大器偏置的原因使其在最大输出工作状态时,无法达到最大电流而导致两个放大器的输出端无法实现最佳负载调制,造成整体效率下降。

互联网摘选

5、

Determination of Allowable Lift Capacity of Forklift after Installing Attachment and its Overload Protection

叉车配置属具后允许起重量的确定及过载保护

互联网摘选

6、

Examination found that except the disinfected toilet tissue hich did not fulfill the standard requirement and no standard for toothpick, the total bacterial count of samples of other items did not exceed the allowable limit.

经检测,除消毒级面巾纸未达标准要求,牙签尚无标准外,其他各项样本污染细菌总数均未超过标准。

provided by jukuu

7、

The principles of allowable emission equal right allocation are expounded and B-value method is put forward.

阐明了允许排放量平权分配的原则,提出了平权分配污染源允许排放量的B值法.

互联网摘选

8、

The precision oft-test was manifested through standard deviation calculation and the allowable deviation was determined.

通过标准偏差计算反映该试验方法的精密度,确定允许差.

互联网摘选

9、

The nominal weight is 60 g, allowable deviation is + 0.1 g and-0.05 g.

标准重量是60克,允许偏移量从负0.05克到正0.1克.

互联网摘选

10、

Most of other workshops showed air dust particles beyond the allowable limit.

不合格车间中,多数为空气尘埃粒子数超标.

互联网摘选

11、

The maximum allowable value of M depends on the data type.

的最大允许值依赖数据类型.

互联网摘选

12、

The requirements for allowable stress design of masonry were retained and strength design provisions were first included in the American Building Code Requirements for Masonry Structures ( ACI 530-02/ ASCE 5-02/ TMS 402-02) in the 2002 edition.

美国砌体结构建筑规范(ACI530~02/ASCE5-02/TMS402-02),2002年规范修订版在容许应力设计原理的基础上,首次给出了砌体结构强度设计准则规定。

互联网摘选

13、

Another important objective of the bill is to strengthen anti-avoidance provisions relating to deductions for interest payments-one of the allowable deductions under profits tax.

条例草案另一重要目标,是加强有关扣除利息支出的防止避税条文。利息支出在计算利得税时是一个可扣除的项目。

provided by jukuu

15、

Strength Design values may be converted to Allowable Stress Design values.

设计要求、强度设计值可转换为许用应力设计值。

互联网摘选

16、

Ultimate state analysis of carrying capacity and tensile fatigue analysis are conducted according to basic combination of loads effect and standard combination of loads effect respectively. Design of foundation screws through allowable stress design method is presented.

按荷载效应的基本组合进行承载能力极限状态分析,按荷载效应的标准组合进行抗拉疲劳分析,采用许用应力设计法进行地脚螺栓的设计。

互联网摘选

17、

As for the calculation, the old allowable stress design method and the more simple formula are adopted, not the present limit condition calculation method and its complicated formula stated in the 《 Steel Structure Design Code 》.

在计算方法上不是采用现行《钢结构设计规范》中的极限状态设计法及其较繁的计算公式,而是采用锅炉行业过去习惯采用的许用应力设计法及其较简单的计算公式。

互联网摘选

18、

Allowable stress and strength design method of masonry code in the United states& flexure design

美国砌体规范的容许应力与强度设计方法&梁的抗弯设计

互联网摘选

19、

Discussion on the Increased Range of Allowable Stress in the Design Code for Industrial Metallic Piping

对工业金属管道设计规范中许用应力提高幅度的探讨

互联网摘选

20、

Based on mechanical analysis and testing research, the paper put forward a calculation method of interlayer allowable shear stress and the design method of asphalt pavement considering shear strength.

并且,在力学分析和试验研究的基础上,提出了层间容许剪应力的计算方法和考虑抗剪强度的沥青路面结构设计方法。

互联网摘选

  • 今日热词
  • 热门搜索

简答网英语词典(dict.jiandongshicai.cn)为您提供在线翻译、英语词典、单词大全、英译汉、汉译英等英语服务!可按单词头尾、字数和词义分类查询。支持lj:关键词格式查询例句。

用户反馈
请选择反馈类型(可多选):
您的联系方式:(如需回复请填写联系方式)
反馈内容:
提交成功 小编会尽快处理
回到顶部
点击反馈