The influence of Mn and Si on microstructure and growth kinetics of cementite particles in severely cold-rolled and annealed Fe-0.8C steel was investigated by using scanning election microscopy, transmission election microscopy and an images analysis approach.

1、

The influence of process condition such as spinning pack, cooling condition, collection oiling, annealed zone, drawing condition etc on products quality were expounded.

探讨纺丝组件、冷却条件及集束上油、缓冷区、拉伸工艺等条件对产品质量的影响。

互联网摘选

2、

Experimental annealing proved that the strip thus annealed has a bright surface and is uniform in mechanical properties and grain sizes.

实验表明退火后的带材表面光亮度良好，机械性能和晶粒度均匀。

互联网摘选

3、

Texture and Formability of Hot Rolled in Ferrite Zone and Annealed Ti-IF Steel Strip

Ti-IF钢铁素体区热轧退火板的织构特征和成形性能

互联网摘选

4、

The precipitated phases in cold rolled and annealed thin steel strip are nano-scaled M3C and nano-scaled MC.

冷硬板和退火薄板中的析出相主要为纳米级的M3C型和MC型析出物。

互联网摘选

5、

The annealed strip is cooled to the temperature required by galvanizing process in the cooling zone and then goes into zinc pot through sealed channel.

将退火带钢在冷却段冷却到指定温度，经密封通道进入锌锅。

互联网摘选

6、

When the aluminum content increases, the grain size of cold-rolled annealed panel becomes small, but the hardness, yield strength and tensile strength of stainless steel 439 increase.

随着439不锈钢合金成分中铝含量的增加，冷轧退火板的晶粒尺寸较小，硬度、屈服强度和抗拉强度升高。

互联网摘选

7、

The tensile strength of drawing wire can reach 1421 MPa. And the highest relative conductivity can reach 30% IACS ( International Annealed Copper Standard). The effects of cold drawing on the properties of electrode wire have been investigated.

拉制硬态电极线抗拉强度可达1421MPa，相对导电率最高可达30%IACS（国际退火（软）铜标准）。

互联网摘选

8、

In this paper, creep tests were carried out on annealed pure copper and normalized bronze containing Al under static and cyclic tension at room temperature.

以退火纯铜及正火铝青铜在轴向拉伸下进行室温静、动态蠕变试验。

互联网摘选

9、

The results show that the ECP of the annealed copper alloys for lead frames can be predicted by the model.

结果表明，在试验范围内，模糊控制对引线框架铜合金时效后导电性能的预测是可行的。

互联网摘选

10、

The causes for the defects on annealed copper wires produced on medium wire drawing machines are investigated and the measures for improving equipment and process as well as circulating cooling system for annealing are presented accordingly.

本文分析了中拉机退火铜线产品质量缺陷产生的原因，并提出了相应的工艺、工装改进措施，对中拉机退火冷却循环系统进行改进。

互联网摘选

11、

Ways to improve the quality of the annealed copper wires produced on the SNL 17D+ 57 kVA Medium Wire Drawing Machine

浅谈提高SNL17D+57kVA中拉机退火铜线质量的几种方法

互联网摘选

12、

The electric-conductivity coefficient of Mo/ Cu FGM attained 27% international annealed copper standard ( IACS), and the thermal-coefficient of third and fourth layer were 204.76 and 249.71?

Mo/Cu FGM电导率为国际退火铜标准（IACS）的27%.第3层、第4层的热导率分别为204.76和249.71W。

互联网摘选

13、

X-ray diffraction was used to estimate the grain size of the annealed nc copper.

X-射线衍射（XRD）的方法用来估算纳米晶铜晶粒尺寸。

互联网摘选

14、

AIM: To explore the changes of myocardial energy metabolism and adenine nucleotide translocase ( ANT) activity in mitochondria in rats exposed to hypoxia.

目的：探讨高原低压缺氧暴露过程中大鼠心肌能量代谢及腺苷酸转位酶活性变化特点。

互联网摘选

15、

Changes of the myocardium energy metabolism and adenine nucleotide translocase activity in rats after hypoxic exposure

缺氧对大鼠心肌线粒体能量代谢和腺苷酸转位酶活性的影响

互联网摘选

16、

Molecular Cloning and Sequence Analysis of Adenine Nucleotide Translocase Gene in Antheraea pernyi

柞蚕腺苷酸转移酶基因的克隆与序列分析

互联网摘选

17、

Conclusions Rat c Jun and mitochondrial adenine nucleotide translocase can bind to the GPE ⅰ core sequence, and they perhaps are the trans action factors of GPE ⅰ.

结论大鼠c-Jun蛋白和线粒体腺苷酸转位酶在酵母细胞内与大鼠GST-P增强子GPE核心序列结合，可能是作用于GPE的反式作用因子。

互联网摘选

18、

The activities of superoxide dismutase ( SOD), carnitine acylcarnitine translocase ( CAT), and the content malondiadehyde ( MDA) were detected in blood serum.

测定血清中丙二醛（MDA）、超氧化物歧化酶（SOD）、过氧化氢酶（CAT）活性。

互联网摘选

19、

Cloning of Adenine Nucleotide Translocase Gene From Bombyx mori Based on EST Database

利用EST库资源克隆家蚕腺苷酸转移酶基因

互联网摘选

20、

Progress in the studies on the Tat translocase in Escherichia coli

大肠杆菌Tat转运酶的研究进展

互联网摘选