The results show that the microstructure of the steel obtained after cooling is proeutectoid ferrite, eutectoid ferrite from the austenite, a little carbide-free bainite, granular bainite and martensite.

1、

It is found that the pre eutectoid ferrite is retarded by addition of B element and the segregation of P and S on the grain boundary is restrained.

研究中发现，在连铸过程中，硼添加到钢中，显著推迟了先共析铁素体的析出，抑制了P，S等元素在晶界的偏聚。

互联网摘选

2、

The pre eutectoid ferrite transformation initiated at the original austenite grain boundaries and formed a net structure.

先共析铁素体沿原始奥氏体晶粒边界生长，形成网状结构。

互联网摘选

3、

The experimental results show that the critical cooling rate of pro-eutectoid ferrite is 0. 1 5 ℃/ s, and the structure of complete granular bainite can be obtained with a cooling rate from 0. 15 ℃/ s to 1 ℃/ s.

试验结果表明，本试验用钢不发生先共析铁素体析出的临界冷却速度为0.15℃／s；冷却速度在0.15～1.00℃／s范围时可得到全部粒状贝氏体组织；

互联网摘选

4、

The critical cooling rate that does not occur pre-eutectoid ferrite is 0.012 ℃/ s.

不发生先共析铁素体转变的临界冷却速度为0012℃/s。

互联网摘选

5、

Characteristics of internal friction and modulus associated with non-equilibrium diffusion-type phase transformation in eutectoid Al-Zn alloy

共析Al-Zn合金非平衡扩散型相变内耗和模量特征

互联网摘选

6、

A Study of m-c-δ( or m-k-δ) Relations of Superplastic Zn-22% Al Eutectoid Alloy

Zn-22%Al合金超塑性的m-C-δ（或m-k-δ）关系的研究

互联网摘选

7、

Usually, excellent Superplasticity of Zn-Al eutectoid alloy could be obtained by pre-deformation ( rolling or forging).

锌铝共析合金具有良好的超塑性，但通常需要经过预变形（轧制或锻压）来得到。

互联网摘选

8、

The Study of Superplastic Mechanism of Zn-Al Eutectoid Alloy

Zn－Al共析合金室温超塑性变形机理

互联网摘选

9、

It was found that the superplasticity was also obtained directly by superplastic treatment of the cast Zn-Al eutectoid alloy.

研究指出，直接由铸造的锌铝共析合金进行超塑性处理，也可以得到超塑性。

互联网摘选

10、

Superplastic Treatment and Application of Cast Zn-Al Eutectoid Alloy

铸造锌铝共析合金的超塑性处理及应用

互联网摘选

11、

In this paper The hardness of grey iron is related to the amount and fineness of pearlite in the matrix, and is effected to a great extent by the amount of primary austenite and its eutectoid structure.

结果表明，灰铸铁的硬度不仅与基体中珠光体的含量和细化程度有关，而且在很大程度上还取决于铸铁结晶过程中初生奥氏体量及其共析转变的结果。

互联网摘选

12、

Zn-Al Eutectoid Structure Formed by Hot Compression

热压法获得Zn-Al共析组织的研究

互联网摘选

13、

Results The melting point of the lidocaine-dodecanol binary eutectic system was markedly lower than that of pure lidocaine.

结果利多卡因-月桂醇二元共熔混合物的熔点明显比利多卡因低。

互联网摘选

14、

Surfactants Improving the Dispersion of RDX in AN-EDD Eutectic System

表面活性剂改善RDX在EA低共熔物体系中的分散性研究

互联网摘选

15、

The Binary Phase Diagram and Eutectic System for DNTF/ PETN

DNTF/PETN体系的二元相图及低共熔物

互联网摘选

16、

Influence of sample thickness on the morphology of eutectic system

试样厚度对共晶组织形态的影响

互联网摘选

17、

Analysis has been carried out for two kinds of eutectic system with different morphology.

对两种不同形态的共晶组织进行了分析。

互联网摘选

18、

At the same time, the addition of aluminum to obtain another eutectic structure which is fine and disperse.

与此同时，铝的加入，获得了细密、弥散的另一共晶组织。

互联网摘选

19、

Investigation on the pseudo eutectic structure formed by solid diffusion of Zn powder and Al powder

Zn粉和Al粉固相扩散形成共晶类组织的研究

互联网摘选

20、

Study shows that quenched boron eutectic structure possesses the excellent wear abrasion property.

研究表明：硼共晶组织经淬火后，具有优良的抗磨粒磨损性能。

互联网摘选